KEYENCE N-400 - Manual (Page 102)

Chapter 5 Multi-Head Mode Control Procedure
94
5
5.2.3 Data transmission timing
Data transmission timing can be selected from the following modes only in single-
label reading mode:
(The data transmission timing cannot be selected in the multil 1/2/3 reading
modes.)
• After reading
This mode allows the BL series to send data immediately after reading them.
This operation is the same as that described in the timing chart in “5.2.2 Trigger
input signal type”. Normally, the data transmission timing should be set to this
mode.
• After trigger input is turned OFF
This mode allows the BL series to send data when the trigger input is turned
OFF. (If the one-shot trigger mode is selected, data is sent after the preset
measurement time has passed.)
Reading
Trigger input
Communication
output
(When the BL series
successfully read bar code data) (When the BL series failed to
read bar code data)
* Read error