KEYENCE N-400 - Manual (Page 47)

Chapter 3 N-400 Setup Procedure
39
3
5. When you click on [Trigger setup], you can set the trigger input in multi-head
mode.
➮ MULTI-DROP LINK (Multi-drop link mode): p. 58
➮ MULTI-HEAD SCAN (Multi-head scan mode): p. 86
➮ Interference Suppression: p. 95
➮ Read mode: pp. 89 to 90
➮ Data-send: p. 92
➮ Read error code: p. 93
TRIGGER SETUP (only when Multi-head scan is selected)
The Trigger Setup screen is used to set the trigger input for Multi-head scan mode.
1. Set “Trigger Input/Signal Type” to “Level” or “One-shot”.
If you select “One-shot”, the one shot input time is displayed.
2. Enter the “Command for Trigger ON” and “Command for Trigger OFF” using the
keyboard. These commands can be changed to any eight character string. Set
these commands so that they conform to the trigger ON/OFF commands of the
connected BL series.
Normally, you should use the default settings (LON and LOFF) without chang-
ing them (as well as the BL series’ trigger ON/OFF commands).
➮ Trigger Input/Signal Type: p. 91
➮ Command for Trigger ON, Command for Trigger OFF: p. 72
Tips
Tips