Sears 385.1883 - Manual (Page 22)

Know What the Presser Feet Will Do
« Check the Presser Foot
The presser feet are an important feature of this machine. You need to know
what each foot does in order to use them effectively.
Your presser toot is held in place by a toot holder. Each presser toot merely
snaps on the toot holder, which is seldom removed,
if you need to remove or attach the foot holder, here is what you do;
To Remove:
Turn the screw toward the back ot
the machine. Use the large screw
driver.
To Attach:
1. Match the hole In the loot holder
with the threaded hole in the
presser bar.
2. Fit the toot holder screw into the
hole.
3. Tighten the screw by turning it
toward you.
e Change the Presser Foot
Use the correct presser foot lor the stitch you wish to sew. Consult the Stitch
Pattern Chart and the detailed directions tor sewing with the various presser
teet.
To Snap Off:
To Snap Off the Presser Fool:
1. Raise the needle bar to its highest
position by turning the hand wheel
toward you.
2. Raise the presser loot.
3. Press the snap-on button on the
back of the toot holder.
The presser toot will drop off.
14
To Snap On the Presser Foot:
1, Place the presser loot so the hori­
zontal pin on the toot lies just under
the groove of the toot holder.
2. Lower the presser foot holder to lock
the presser foot in place.
NOTE: If you do not hear the presser
foot snap in place, press
down on the presser toot
holder firmly until you hear
the snap.