EXFO IQS-2400 WDM Laser Source for IQS-500/600 - Manual (Page 141)

SCPI Command Reference
WDM Laser Source 135
Product-Specific Commands—Description
In On/Off modulation, make sure that this value
is not lower than the value returned by
SOURce[1..n]:PULM:LIMit:FREQuency:OMIN?.
To set the frequency of the internal dither or
On/Off modulation signal, use the
SOURce[1..n]:PULM:INTernal:FREQuency[1|2]
command.
See Also SOURce[1..n]:PULM:INTernal:FREQuency[1|2]?
SOURce[1..n]:PULM:INTernal:FREQuency[1|2]
SOURce[1..n]:PULM:STATe
SOURce[1..n]:PULM:STATe?
SOURce[1..n]:PULM:LIMit:FREQuency:DMAX?
SOURce[1..n]:PULM:LIMit:FREQuency:DMIN?
SOURce[1..n]:PULM:LIMit:FREQuency:OMAX?
SOURce[1..n]:PULM:LIMit:FREQuency:OMIN?
SOURce[1..n]:PULM:LIMit:FREQuency[:RANGe]:
COUNt?
SOURce[1..n]:PULM:LIMit:FREQuency[:RANGe]:
HIGH?
SOURce[1..n]:PULM:LIMit:FREQuency[:RANGe]:
STEP?
:SOURce[1..n]:PULM:LIMit:FREQuency
[:RANGe]:LOW?