EXFO IQS-2400 WDM Laser Source for IQS-500/600 - Manual (Page 144)

SCPI Command Reference
138 IQS-2400
Product-Specific Commands—Description
In On/Off modulation, make sure that this value
does not exceed the value returned by
SOURce[1..n]:PULM:LIMit:FREQuency:OMAX.
To set the the frequency of the internal dither or
On/Off modulation signal, use the command
SOURce[1..n]:PULM:INTernal:FREQuency[1|2].
See Also SOURce[1..n]:PULM:INTernal:FREQuency[1|2]?
SOURce[1..n]:PULM:INTernal:FREQuency[1|2]
SOURce[1..n]:PULM:STATe
SOURce[1..n]:PULM:STATe?
SOURce[1..n]:PULM:LIMit:FREQuency:DMAX?
SOURce[1..n]:PULM:LIMit:FREQuency:DMIN?
SOURce[1..n]:PULM:LIMit:FREQuency:OMAX?
SOURce[1..n]:PULM:LIMit:FREQuency:OMIN?
SOURce[1..n]:PULM:LIMit:FREQuency[:RANGe]:
COUNt?
SOURce[1..n]:PULM:LIMit:FREQuency[:RANGe]:
LOW?
SOURce[1..n]:PULM:LIMit:FREQuency[:RANGe]:
STEP?
:SOURce[1..n]:PULM:LIMit:FREQuency
[:RANGe]:HIGH?