EXFO IQS-2400 WDM Laser Source for IQS-500/600 - Manual (Page 56)

Controlling Multiple WDM Laser Source Modules
50 IQS-2400
Setting Up Multiple IQS-2400 WDM Laser Source Modules
To modify a particular parameter (all are set the same way):
1. Select the tab associated with the parameter to be modified.
2. Use the and buttons to define the value that will be added to the
parameter value. If you want to decrease the parameter value, make
sure that the offset is negative.
Note: You can modify the step used when you increase or decrease the offset
value. Use the Offset Step up/down arrows to modify the step.
3. When you are satisfied with the offset value, use to confirm the new
setting.
Note: If the new offset value is out of the permitted range, the application displays
an error message.
To set the control mode:
For information, see Selecting a Control Mode on page 21.
I
MPORTANT
Before setting parameters or turning sources on, make sure that
their corresponding boxes are selected.
Apply button
Control
modes