WaveWare CommTech MaxPage - Manual (Page 3)

Manual MAXPage
© Commtech Wireless Page 3
COMPLIANCE NOTICES
SAA (C-TICK AUSTRALIA)
To ensure compliance with ACA Technical Standards, this equipment is labeled with a Telecommunications Compliance
Label. For safety reasons, this equipment should only be connected to compliant telecommunications equipment in
accordance with the manufacturer’s instructions.
FCC PART 15
Where applicable, this equipment has been tested and found to comply with FCC Rules and Regulations, Part 15 with the
limits of a Class B digital device, designed to provide reasonable protection against harmful interference. This equipment
generates, uses and can radiate frequency energy and if not installed and used in accordance with the instructions, may
cause interference harmful to radio communications. On the base of the equipment is a label containing an FCC Registration
Number, if applicable.
FCC PART 68 & IC (INDUSTRY CANADA)
This equipment complies with Part 68 of the FCC rules. Located on the equipment is a label that contains, among other
information, the FCC registration number and ringer equivalence number (REN.) If requested, this information must be
provided to the telephone company.
The REN is used to determine the quantity of devices which may be connected to the telephone line. Excessive REN’s on the
telephone line may result in the devices not ringing in response to an incoming call. In most, but not all areas, the sum of the
REN’s should not exceed five (5.0). To be certain of the number of devices that may be connected to the line, as determined
by the total REN’s contact the telephone company to determine the maximum REN for the calling area.
This equipment cannot be used on the telephone company-provided coin service. Connection to Party Line Service is subject
to State Tariffs.
If this equipment causes harm to the telephone network, the telephone company will notify you in advance that temporary
discontinuance of service may be required. If advance notice isn’t practical, the telephone company will notify the customer as
soon as possible. Also, you will be advised of your right the file a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations, or procedures that could affect the
operation of the equipment. If this happens, the telephone company will provide advance notice in order for you to make the
necessary modifications in order to maintain uninterrupted service.
If trouble is experienced with this equipment, please contact:
Company Name: Commtech Wireless
Address: 6900 Philips Hwy, Jacksonville Florida 32217, USA
TEL: +1 904 281 0073 FAX: +1 904 281 0074
If the trouble is causing harm to the telephone network, the telephone company may request you to remove the equipment
from the network until the problem is resolved.
This equipment uses the following USOC jacks: RJ11C
It is recommended that the customer install an AC surge arrester in the AC outlet to which this device is connected. This is to
avoid damaging the equipment caused by local lightening strikes and other electrical surges.