WaveWare CommTech MaxPage - Manual (Page 57)

Manual MAXPage
© Commtech Wireless Page 57
6. USING THE WINDOWS® SOFTWARE
The diagram below shows the Main screen of the Windows® MAXPage software. Each area
will be discussed in detail below.
6.1 Connecting to the MAXPage unit
The software must connect to the MAXPage unit for configuration. Before it can connect, the
communication settings of the software must match that of the MAXPage unit.
1. To configure these settings select File -> Connection Settings. The default settings
are shown below which are normally correct.
™ NOTE: The correct com Port the unit is connected to on the PC must be
selected. This is usually written next to the com port itself on the rear of the PC.