WaveWare CommTech MaxPage - Manual (Page 70)

MAXPage Manual
Page 70 © Commtech Wireless
6.4.3 Interface Communications
• If you are connecting MAXPage to another piece of paging equipment that outputs
the TAP, COMP1, COMP2 or SCOPE protocols you will need to set the Protocol
field to the correct type.
• The Speed, Data Bits, Stop Bits, Parity and Flow Control fields must match that of
the piece of equipment being connected to MAXPage. These fields control the serial
communication. Consult the documentation that came with the paging system for
more information.
• The fields below are dependant on the type of protocol that was chosen in the
Protocol field. These are outlined on the next screen.