WaveWare CommTech MaxPage - Manual (Page 71)

Manual MAXPage
© Commtech Wireless Page 71
TAP
o
Lookup Local ID – Placing a tick in this box means that TAP messages must contain
a Pager ID. MAXPage will lookup the Pager ID within its internal database and send
the message to the appropriate recipient. Un-ticking the box means that the TAP
message must contain a cap code. MAXPage will send the message to the cap code
specified.
o
Ignore Checksum – Placing a tick in this box will ignore messages with an incorrect
checksums and process them regardless.
o
Never Disconnect – Placing a tick in this box will force MAXPage to stay connected
to the device attached to it.
o
Accept messages to invalid pagers – Placing a tick in this box will force MAXPage
to accept messages it deems invalid and attempt to process them. This means that
MAXPage will be less strict with TAP protocol standards, as some devices use a very
simple version.
o
Send ‘ID=’ every two seconds – Placing a tick in this box will force MAXPage to
send ‘ID=’ every 2 seconds. Some paging systems require MAXPage to indicate its
readiness to receive messages, by outputting a prompt ‘ID=’ every 2 seconds.
Consult the documentation that came with the TAP device you are attaching to
MAXPage, for more information if this is required or not.
COMP 1
o
COMP 1 Local ID – COMP 1 is a very simple protocol. COMP 1 messages contain
the message without a recipient. For this reason the only field that needs to be setup
for COMP 1 is a target Pager ID that will be sent the COMP1 messages that
MAXPage receives.
COMP 2
o
Lookup Local ID – Placing a tick in this box means that COMP 2 messages must
contain a Pager ID. MAXPage will lookup the Pager ID within its internal database
and send the message to the appropriate recipient. Un-ticking the box means that the
COMP 2 message must contain a cap code. MAXPage will send the message to the
cap code specified.
SCOPE
o
Lookup Local ID – Placing a tick in this box means that SCOPE messages must
contain a Pager ID. MAXPage will lookup the Pager ID within its internal database
and send the message to the appropriate recipient. Un-ticking the box means that the
SCOPE message must contain a cap code. MAXPage will send the message to the
cap code specified.