Basler Electric BE1-11g - Manual (Page 219)

9424200994 Rev N 207
Name Description
S Demand Apparent power (VA) demand maximum exceeded
Setting Change Setting change made by user
Settings Group 0 Setting group 0 is active
Settings Group 1 Setting group 1 is active
Settings Group 2 Setting group 2 is active
Settings Group 3 Setting group 3 is active
SGC Active Active setting group changed
SGC Logic Override Setting group control was overridden by logic
Trip Coil Monitor Monitored trip circuit open
uP Reset Alarm Microprocessor watchdog circuit timed out
Var Negative Demand Negative var demand maximum exceeded
Var Positive Demand Positive var demand maximum exceeded
Watt Forward Demand Forward watt demand maximum exceeded
Watt Reverse Demand Reverse watt demand maximum exceeded
Alarm Settings
BESTCOMSPlus Navigation Path: Settings Explorer, Alarm Configuration, Alarms
HMI Navigation Path: Not available through the front panel
Alarms are enabled using BESTCOMSPlus. Use the Settings Explorer to open the Alarm Configuration,
Alarms tree branch. Configure alarms by selecting Disabled, Latching, or Non-Latching from the Minor,
Major, and Logic drop-down menus next to the alarms. Refer to Figure 143.
Figure 143. Alarm Settings Screen
User Programmable Alarms
BESTCOMSPlus Navigation Path: Settings Explorer, Alarm Configuration, User Programmable Alarms
HMI Navigation Path: Not available through the front panel
Sixteen user programmable alarms are available. BESTlogicPlus Programmable Logic is used to set up
alarm logic. User alarm labels are programmed on the User Programmable Alarms screen (Figure 144)
BE1-11g Alarms