Comtech EF Data CST-5000 - Manual (Page 37)

CST-5000 C-Band Satellite Terminal Single Thread System Installation
Rev. 9 2–9
2.3.2 Vertical Pole Installation
2.3.2.1 Round Pole
Note: The following process is for a typical installation. Custom systems may be ordered,
and are beyond the scope of this manual.
To install the RFT to a round vertical pole:
1. Set the unit on its side, with the mounting holes facing up.
2. Install the 8 inch (20.3 cm) unistruts as follows:
a. Position an 8 inch (20.3 cm)
unistrut (with the open side
facing up) over one set of
the mounting holes on the
RFT.
b. Using four 1/4-20 x 1 inch
(2.54 cm) bolts, 1/4 inch
(6 mm) split lockwashers,
and 1/4 (6 mm) flat washers,
attach an 8 inch (20.3 cm)
unistrut to the RFT.
Tighten the bolts firmly.
c. Repeat Steps 2.a. and 2.b.
for the second 8 inch
(20.3 cm) unistrut.