Comtech EF Data CST-5000 - Manual (Page 49)

CST-5000 C-Band Satellite Terminal Single Thread System Installation
Rev. 9 2–21
2.5 External Connections
Connections between the RFT and other equipment are made through six connectors.
These connectors are listed in Table 2-1, and their locations are shown in Figure 2-4. The
use of each connector is described in the following paragraphs.
Cables for connectors J3, J4, and J5 are supplied by EFData. A connector kit for the
remote connector, J6, is also supplied. All others must be supplied by the customer.
Table 2-1. Rear Panel Connectors
Name Ref. Design. Connector Type Function
TX/IF IN J1 TNC TX IF INPUT (70 MHz)
TX/RF OUT J2 Type N 5.845 to 6.425 GHz Out
RX/IF OUT J3 TNC RX IF OUT (70 MHz)
RX/RF IN J4 Type N 3.620 to 4.200 GHz Input
PRIME PWR J5 3- or 4-pin CIR Prime Power Input
REMOTE J6 26-pin CIR Remote Interface
GND ERDE GND #10-32 Stud Chassis Ground
Figure 2-4. RFT External Connections