Comtech EF Data CST-5000 - Manual (Page 44)

Single Thread System Installation CST-5000 C-Band Satellite Terminal
2–16 Rev. 9
c. Install a 5/16 inch (8 mm) flat washer, 5/16 inch (8 mm) split lockwasher,
and 5/16-18 nut on each threaded rod.
d. Position the RFT as desired, and tighten the 5/16-18 nuts installed in
Step 6.c.
e. Slide the pipe blocks inward until they contact the vertical pole, then firmly
tighten the 5/16-18 bolts.
2.3.2.2 Square Pole
For square vertical pole installation, follow the steps in Section 2.3.2.1, with the
following exceptions:
• Do not perform Step 4.
• Do not perform Step 6.e.