NavCom SF-3040 Rev.F - Manual (Page 106)

SF-3040 Product User Guide
– Rev. F
5-104
 Base and Rover Navigation Setup
NavCom’s StarUtil 3000 provides Base and Rover
setup capabilities. Refer to the StarUtil 3000 User
Guide for details. The guide is included on the
supplied SF-3040 Product Configuration USB flash
drive and is also available on the NavCom web site.
User Profiles
The SF-3040 utilizes commands or groups of
commands, known as User Profiles, to set the various
port assignments/parameters, navigation parameters,
and output message lists. A file with commonly used
user profiles is included on the supplied USB flash
drive.

The SF-3040 provides for storage of up to 20 user
profiles. Profiles may also be stored on a PC.
Each user profile is stored with a name. The user
profile extension is *.npt.

StarUtil 3000, or another controller solution, is
used to upload a user profile by its name.

The SF-3040 may be initially configured with the
factory default user profile or with a profile
customized for the user by an authorized dealer.

Predefined, commonly used profiles are included
on the supplied SF-3040 Product Configuration
USB flash drive or are available by email.

To save the current configuration settings in the
receiver for future use, the user creates a profile
and assigns it a name.

If the current settings are not saved to a
profile and then made the active
settings, the current settings will be
overwritten by the last activated profile at
the next power cycle or processor reset.