NavCom SF-3040 Rev.F - Manual (Page 37)

SF-3040 Product User Guide
– Rev. F
1-35
5. If the NAV firmware installed in the receiver is not
the most current version:

Check the versions of the other firmware.

Write down all of the firmware that must be
updated.

Go to the section below, Upload Firmware .
Upload Firmware Files

The required PC Baud rate to upload
firmware via the supplied DB9S cable
(RS-232) on COM2 is 57600 (default).
This requirement does not apply to the
supplied USB 2.0 Device cable.

The receiver must be navigating at the
time of the firmware upload. While the
firmware will be accepted and applied
properly, option and license files require
date and timestamp verification.

Typically, if any firmware needs to be updated,
it is NAV and PIOAPP.
1. Click Receiver Options on the Detailed Views
menu to open the Receiver Options tab (refer to
Figure 13).