NavCom SF-3040 Rev.F - Manual (Page 117)

SF-3040 Product User Guide
– Rev. F
6-115
LEDs indicate the status of the batteries, not
the status of the external power source.
All new batteries must be charged for a
minimum of 12 hours prior to use,
regardless of the LED indicator on the
charger.
Installing the Battery Packs in the
SF-3040
The battery chambers are located on the side of the
SF-3040. There are two locking clips on the outside
edge of each battery chamber to hold the battery
packs in place.
Follow these steps to install the battery packs in the
SF-3040:
1. Open the battery pack chamber (located on the
left-hand side of the SF-3040 as you hold the
receiver with the front facing toward you) by
pressing downward on the black button (refer to
Figure 53).
Figure 53: Battery Chamber Release Button
2. Align the battery pack with the chamber.
Release
Button