Quintum Technologies Tenor AX - Manual (Page 58)

P/N 480-0062-00-10 4-3
Chapter 4: Advanced Topic: View Call Detail Records
Establish connection between Tenor AX and CDR Server
In order to capture CDRs, a connection between the Tenor AX unit and the CDR server must be
established. A Tenor AX can be configured to connect up to two CDR servers via ports 9002 and
9003. Based on configuration, the Tenor AX unit can either establish a TCP/IP session with one or
all of these CDR servers. A flow diagram (Figure 4-1) illustrates the general transfer of information.
Figure 4-1 Flow of CDR Information
Before attempting to collect CDRs, you should configure the desired information. You can assign a
CDR server IP address, CDR server port number, CDR server password, and CDR format informa-
tion using the following CLI commands: cdrserverip, cdserverport, cdrpassword, and cdrformat.
• CDRServerIPAddr: IP address of the CDR server. (Used when the Tenor AX unit established
connection with the CDR server.)
• CDRServerPort: The application port numbers used by the CDRServer(s). (Used when the
Tenor AX establishes connection with CDR server.)
• CDRPassWord: Password to be used by the CDR server(s).
• CDRFormat: This configuration parameter command is used to choose which of the possible
Call Data Record output formats you would like to send to your CDR Server. See
CDR Output .
Configure Tenor AX for connection to CDR Server
NOTE: The CDR Server software is a Windows-based.exe file available on the CD you received
with your system; this software is not supported by Quintum.
Tenor CMS CDR Server
Tenor CMS connects
to CDR Server automatically.
(after initial configuration of
S erver IP Address & Port Number)
or
CDR Server logs into Tenor CMS'
Port Number 9002 or 9003
TCP/IP Connection Established
Sends Welcome Message
Sends Password Prompt
Enters Password
Verifies Password
Provides CMS' IP address &
U nit N ame
Provides last CDR Sequence
Number received
Begins delivering CDR's
Tenor AX
AX’s
AX
AX’s