Quintum Technologies Tenor AX - Manual (Page 64)

P/N 480-0062-00-10 4-9
Chapter 4: Advanced Topic: View Call Detail Records
Local IP Address: The IP address for the Tenor AX unit originating the CDR. The entry will be in
the following format: xxx.xxx.xxx.xxx.
Remote IP Address: IP address for the remote destination Tenor AX. This will be generated only if
the call is VoIP; if the call is circuit based, this field will be blank. The entry will be in the following
format: xxx.xxx.xxx.xxx.
Origination Trunk ID: Identifies the origination trunk ID of the line that initiated the call. This
field will be blank if no trunk ID is configured. The trunk ID is often configured with an account
code.
Call Type: The type of call. Valid entry: 1 = voice, 2 = fax, 3 = modem, 4 = data.
Call Number Type: The called numbering plan used for the call per Q.931. Possible common
entries are as follows: 1 = Public/E.164, 9 = Private.
Incoming Line: If the call is incoming, this field identifies which line the call came in on. Valid
entry: 1 = PBX, 2 = PSTN. This field will be empty if the call is an incoming VoIP call.
Incoming Channel: If the call is incoming, this field identifies which channel the call came in on.
Valid entry: 1-4. This field will be empty if the call is an incoming VoIP call.
Outgoing Line: If the call is outgoing, this field identifies which line the call is going out on. Valid
entry: 1 = PBX, 2 = PSTN. This field will be empty if the call is an outgoing VoIP call.
Outgoing Channel: If the call is outgoing, this field identifies which channel the call went out on.
Valid entry: 1-4. This field will be empty if the call is an outgoing VoIP call.
Autoswitch Time: This is the date and time the autoswitched occurred (when the call is switched
from VoIP to circuit). The entry will be in the following format: yyyymmddhhmmss where yyyy (4
digits for year), mm (2 digits for month), dd (2 digits for day), hh (2 digits for hour), mm (2 digits
for minutes), ss (2 digits for seconds). If an autoswitch did not occur, this field will be blank.
AutoSwitch Duration: The number of seconds that the autoswitch call was active. Valid entry: xx.
Bad IP Quality Events: The number of bad quality events that occur during a VoIP call. This num-
ber determines the overall quality of the call.
Autoswitch Flag. The terminating side of the autoswitch call initially terminates to the internal
autoswitch agent before the call is actually autoswitched. This termination generates an extra CDR
in addition to the original call that is autoswitched. This field identifies a call that is terminated to
the autoswitch agent, 0 = normal call, 1 = termination to the autoswitch agent.
47 Resource Unavailable, Unspecified. This cause is used to report a
resource unavailable event only when no other cause applies.
Cause Code Definitions