Connecting the power, Beware of condensation, Cleaning the unit – Teac SS-CDR200 User Manual

Page 10: About usb memory, sd cards and cf cards, Precautions for use, Sd card write-protection, Media formatting, About compact discs, Handling of compact discs, Unit sd card write-protection media formatting

Advertising
background image

10

TASCAM SS-CDR200/SS-R200/SS-R100

Connecting the power

• Insert the included power cord into the AC IN

connector completely.

• Hold the power cord by the plug when connecting or

disconnecting it.

Beware of condensation

If the unit is moved from a cold to a warm place, or

used immediately after a cold room has been heated or

otherwise exposed to a sudden temperature change,

condensation could occur. Should this happen, leave the

unit for one or two hours before turning the unit on.

Cleaning the unit

To clean the unit, wipe it gently with a soft dry cloth. Do

not wipe with chemical cleaning cloths, benzene, paint

thinner, ethyl alcohol or other chemical agents to clean

the unit as they could damage the surface.

About USB memory, SD cards and CF

cards

This unit uses USB memory, SD cards and CF cards for

playback and recording.
A list of USB memory, SD cards and CF cards that we

have confirmed to work with this unit is provided on our

website (http://tascam.com/).

Precautions for use

USB memory, SD cards and CF cards are delicate media. In

order to avoid damaging a memory/card or the memory/

card slot, please take the following precautions when

handling them.
• Do not leave them in extremely hot or cold places.
• Do not leave them in extremely humid places.
• Do not let them get wet.
• Do not put things on top of them or twist them.
• Do not hit them.
• Do not insert or remove a USB memory, SD card or CF

card during recording, playback, data transfer or other

operations that access a memory or card.

• Do not carry them with terminals exposed. Use the

protective cover.

Media that has been confirmed for use with

this unit

This unit uses USB memory, SD cards and CF cards for

playback and recording.
Microdrives cannot be used with this unit.

The capacities and performance of your unit will vary

based on the speed and abilities of the media used. Older

and some cheaper USB memory/SD cards/CF cards use

slower memory components and little internal buffering

which results in poor recording performance.
A list of USB memory/SD cards/CF cards that we have

confirmed to work with this unit is provided on our

website (http://tascam.com/).

SD card write-protection

This unit writes track information to the media in order to

improve performance. Since track data cannot be written

to write-protected SD cards, media reading will take

longer and performance could otherwise be affected.

Media formatting

Flash media that has been formatted by this unit is

optimized for performance during recording. Using

flash media that has been formatted by a computer,

for example, could result in errors during recording. We

recommend that whenever possible you use flash media

after it has been formatted by this unit.

About compact discs

In addition to commercially-available music CDs, this unit

can play CD-R and CD-RW discs that have been recorded

in audio CD format, as well as CD-R and CD-RW discs that

have MP3 audio and WAV audio files recorded on them. In

addition to 5-inch CDs, it can also play 3-inch CDs.

Handling of compact discs

• For recording, use compact discs that have one of the

following marks.
CD-R

CD-RW

• Always insert the compact discs in the slot with their

label facing upward.

• To remove a disc from its case, press down on the

center of the disc holder, then lift the disc out, holding

it carefully by the edges.

• Do not touch the signal side (the unlabeled side).

Fingerprints, oils and other substances can cause errors

during playback.

1 − Introduction

Advertising
This manual is related to the following products: