Teac SS-CDR200 - Manual (Page 79)

TASCAM SS-CDR200/SS-R200/SS-R100
79
If the unit is not functioning properly, please check the
following items before calling for service. If you are still
unable to resolve the problem please contact the retailer
where you purchased the unit or TASCAM customer
support.
8 Power does not turn on
Confirm that the power plug is inserted completely.
8 Media is not detected
• Confirm that the USB/SD/CF media is inserted
completely.
• Stop playback or recording once.
8 Unit cannot be controlled from the front
panel
Confirm that the panel lock function is not on.
8 Unable to playback a file
If it is a WAV file, confirm that it uses a sampling frequency
(44.1 kHz or 48 kHz) and a bit rate (16/24-bit) that are
supported by this unit. If it is an MP3 file, confirm that it
uses a bit rate that is supported by this unit.
8 No sound
Confirm the connections with the monitoring system and
check the volume of the amplifier.
8 Unable to record
• Confirm the connections.
• Adjust the recording level.
• If the media does not have enough open space, erase
unneeded data to make more space or change the
media.
• If the folder already contains a large number of entries
(the total number of files, folders and other items),
change the recording folder.
8 Changed settings are not saved
This unit backs-up settings whenever you change them.
This backup could fail if you turn OFF the power while
this data is being written, so do not turn OFF the power
immediately after changing a setting.
8 I hear noise
Check if any connecting cable might have a bad
connection.
8 When editing text, “Name Full” appears
Due to limitations of the system, a maximum of 255
characters (single-byte) can be used for items such as file
and folder names. Since this limitation applies to the full
path in the
FINDER
screen, the maximum name length
for items inside a folder are reduced by the number
of characters used by all the folders above it and any
separator characters.
16 − Troubleshooting