Teac SS-CDR200 - Manual (Page 70)

70
TASCAM SS-CDR200/SS-R200/SS-R100
Erasing tracks
You can erase tracks that have been recorded in audio CD
format on a CD-RW disc. The specified track and all later
tracks (until the last track on the disc) will be erased.
1 Press the MENU [JOG] button (or remote control
MENU button) to open the
MENU
screen.
2 Open the
CD
menu.
3 Select
ERASE
.
4 Press the MULTI JOG dial (or remote control ENTER
button) to open a pop-up window where you can
select the
Erase Track
item.
5 Turn the MULTI JOG dial (or press the remote
control 5 and b buttons) to select
Erase Track
.
6 Press the MULTI JOG dial (or remote control ENTER
button) to enable selection of the first track in the
range of tracks that will be erased.
7 Turn the MULTI JOG dial (or press the remote
control 5 and b buttons) to select the first track
to erase in the range of tracks that will be erased.
In the example above, track
03
is selected.
The last track to be deleted (shown as
03
in the
illustration above) is fixed as the last track of the disc
and cannot be changed.
8 After you have selected the first track, press the
MULTI JOG dial (or remote control ENTER button).
A confirmation pop-up message appears.
9 Press the MULTI JOG dial (or remote control ENTER
button) again to start erasing tracks.
-- ERASE --
and a progress bar appear in a pop-up
while tracks are being erased.
After the tracks have been erased, the
CD
menu will
reopen.
NOTE
• When erasing tracks on a finalized CD-RW disc, the unit
will unfinalize the disc before erasing the designated
tracks.
• This operation can be executed only on a disc that has
audio CD format files
Refreshing discs
You can refresh (completely erase) a CD-RW disc. The unit
might not be unable to recognize a CD-RW disc in some
cases, such as if finalization was interrupted by a power
failure, or if a disc has been used by a computer. In such
cases, follow these procedures to refresh the CD-RW disc
so that the unit can recognize it.
1 Press the MENU [JOG] button (or remote control
MENU button) to open the
MENU
screen.
2 Open the
CD
menu.
3 Select
ERASE
.
4 Press the MULTI JOG dial (or remote control ENTER
button) to open a pop-up window where you can
select the
Refresh
item.
5 Turn the MULTI JOG dial (or press the remote
control 5 and b buttons) to select
Refresh
.
6 Press the MULTI JOG dial (or remote control ENTER
button).
A confirmation pop-up message appears.
7 Press the MULTI JOG dial (or remote control ENTER
button) again to start refreshing the CD-RW disc.
-- REFRESH --
” and a progress bar appear in a
pop-up while the disc is being refreshed.
After the CD-RW disc gas been refreshed, the
CD
menu
will reopen.
11 − CD-RW management (SS-CDR200 only)