Verilink AS100 (896-502379-001) Product Manual - Manual (Page 91)

Access System Centum Series User Manual 6-17
Printer Configuration
To configure the SERIAL
1
Printer port, use the Centum Series control
panel to enter ( SELECT ) the Utilities menu. Use the UP/DOWN arrows
to locate NMS/Prt Port and the SELECT again. If necessary, use the UP/
DOWN arrows to locate Mode.
Repeatedly SELECT until the mode indicates Printer. Note that the
NMS function is not operational in this Centum Series revision.
Use the UP or DOWN arrow to display Speed and then SELECT to choose
the desired printer data rate. Finally, END twice to return to the Main
Menu.
The printer should be configured for the same data rate as the Centum
Series printer port and 8-N-1 character coding. All data is output with
both a CR and an LF at the end of each line. Printer “word wrap” is
unnecessary and the printer should not add an LF to each received CR.
1. This is a non-standard printer port. Most printers are parallel, not serial.