Verilink FrameStart FSM (34-00299.E) Product Manual - Manual (Page 22)

2-2 F r a m e S t a r t F S M
For specific applications, see Optional Equipment on page A-5 for additional
cables and adapters. Contact Technical Support (see page x) for further
assistance.
Installation Wizard
The FSM can be configured and monitored through the Web Server interface,
the VT100 interface, or the Front Panel interface, but the unit must first be
configured with an IP address. You can configure the unit’s IP address using
either the LCD on the front panel (refer to the TCP/IP Configuration Menu on
page 5-11) or the Verilink Configuration Wizard, which is included on your
documentation CD.
NOTICE: You may also access the Verilink Configuration Wizard on
Verilink’s Web site: www.verilink.com.
To configure the IP Address using the Verilink Configuration Wizard, perform
the steps listed below:
1 Using the supplied cable, connect the unit’s DB-9 Supervisory port to a
COM port on your PC. (Take note of which COM port is connected.)
2 Insert the Verilink CD-ROM disc (provided with the FSM) into your PC’s
CD-ROM drive.
3 Use Windows “Explore” to view the contents of the CD and select the
folder labeled “Utilities.” In this folder will be a file named
ipwiz.exe ;
this executable file is the Verilink Configuration Wizard application.
Double-click on this file to launch the program. After the program is fully
launched, you will see the following screen:
4 Using the Tab key to move from field to field, move the cursor to the “COM
Port” field. Using the Spacebar, toggle between the available options until
the correct COM port is shown (COM1, COM2, COM3 or COM4). Be sure
to choose the same COM port as the port to which the unit is connected.