Verilink FrameStart FSM (34-00299.E) Product Manual - Manual (Page 25)

W e b S e r v e r I n t e r f a c e 3-1
C H A P T E R
3
C HAPTER 3
W
EB
S
ERVER
I
NTERFACE
The FSM has an innovative, embedded Web-based user interface (WANsight)
for remote configuration and real-time reporting via Microsoft Internet
Explorer 5.0 or higher. Access to the Web server interface and how the
interface is used to configure the FSM0 unit are described in detail below.
NOTICE: Verilink recommends the use of Microsoft’s Internet Explorer 5.0 or
higher because if you use other Internet browsers to access the Web
server interface, screen elements will not display as described in this
manual.
NOTICE: The material presented in this chapter follows the order listed in the
navigation bar on the left side of the Web Server interface screen.
However, because the parameters you specify in the Service Table
attach protocols to interfaces, you must configure the Service Table
first. (See Services Screen on page 3-16.) You will not be able to
allocate channels (see Channel Table Details Screen on page 3-18)
until the Service Table has been configured.
Configuration through the VT100 interface is covered in Chapter 4, and
configuration through the Front Panel interface is covered in Chapter 5.
Web Server Interface Access
You can access the Web server interface by connecting to its IP address. This
connection can be directly through the 10/100 Ethernet port, in-band via PPP
over any port, or in-band via encapsulated IP traffic on the Frame Relay
circuit.
NOTICE: Any changes to the unit’s configuration MUST be followed by a
“Submit” if there is a “Submit” key on the menu. If you change
the Service Table, you must per
f orm a “Save and Restart.”