Verilink QUAD/IMUX (880-502392-001) Product Manual User Manual
Page 65
T1 Configuration Menus
Verilink QUAD/IMUX User Manual
4-13
M
Modem Parameters—Not supported by this product.
R
Reset Card—Restarts the QUAD 2164 without loading firmware from either
flash partition. Similar to a warm boot on a PC. Do not use reset card to test
firmware upgrades, the newly installed firmware will not be loaded. Press “
Y
”
to confirm you wish to restart the module. Any Telnet session will be
dropped, user data will be disrupted.
P
Change Password—Sets privileged and unprivileged passwords. At the
Password Menu, type “P” to set privileged passwords. Type “U” to set
unprivileged passwords. Privileged users have network administrator
permissions and can change all parameters. Unprivileged users have run time
access to QUAD 2164 module capabilities, but cannot make changes to
parameters.
Q
Query Firmware—Verifies the status of the firmware and memory in the
active partition (A or B). When you type “Q’, the screen reports the version
level and status of the partition firmware and RAM.
Y
Switch Over Once—Switches the active firmware partition (used typically to
test new firmware). At the prompt, select the partition (A or B) to switch to
temporarily. When you reboot the card, the original partition will be used.
Any Telnet session will be dropped, user data will be disrupted.
O
Switch Over Permanent—Permanently switches the active firmware partition.
At the prompt, select the partition (A or B) to switch to permanently. When
you reboot the card, this new partition is used as the boot partition. Any
Telnet session will be dropped, user data will be disrupted.
W
Write File to Flash—Updates the flash image in the nonactive partition.
Requires overwrite confirmation of the nonactive partition.
B
Change ACP Bus—Changes the ACP communications bus used to
communicate with an NCM 2000 or other modules in the shelf. You must
reset the card to make the change effective. In most cases, Bus C
should be
selected for QUAD/IMUX applications.
X
Main Menu—Return to the Main Menu.
Command/Field
Description