Visara UCT-L - Manual (Page 110)

6-48 707108-001
UCT-L User’s Manual
Click OK to save changes and close Communications Setup, or Cancel to close and
discard any changes.
Connecting to a VT220 session
VT220 will connect to the remote host. The host then will normally respond with a
welcome and will lead you through its log in process. Log in, employing one of the
following combinations:
• With the userid and password supplied by the administrator of the host
• With just a userid (some hosts do not require passwords)
• Neither, if the remote host has been set up for it.
To connect to a VT220 remote host from the main VT220 screen:
1. Click Session to open the VT220 Session menu.
2. Click Connect.
Once connected, use the menus, commands and features of the remote host to access
and run VT220 applications.
Logging out of a remote host
1. When you have finished using the remote host, use the host’s normal log out command.
2. To disconnect from the host, select Disconnect from the Session menu.