Visara UCT-L - Manual (Page 47)

707108-001 4-23
Chapter 4. 1480 CUT Emulator
Swap session
Press and hold the Alt key while pressing the Swap key to switch sessions without
moving the cursor. For example, in side-by-side mode, if the left session is the active
session (and has the cursor), press the Alt - Swap key combination to move the left
session to the right and the right session to the left. The session on the left is still the
active session and has the cursor.
Example of Swap Session
Session 2
(active session) Session 1
(inactive session) Session 3
(active session) Session 1
(inactive session)
Mark
To select a field as the source field for a subsequent paste operation, position the cursor
anywhere within the field and hold down the Alt key while pressing the F4 key (Mark).
See Mark/Paste below for a complete description.
Paste
To select a field as the target field and paste source data into that field, move the cursor
to the target field and hold the Alt key while pressing the F5 key (Paste). The data in the
source field is pasted into the target field. If there is already data in the target field, that
data is overwritten with the data from the source field. See Mark, above, for instructions
on how to select a source field. The target field cannot be in the same session as the
source field. See Mark/Paste below for additional information about mark and paste.
Mark/Paste
Use the Mark/Paste feature to copy data between sessions. With this feature, data can
quickly be marked and pasted between fields in different sessions.
Mark field
The mark field is the field highlighted as the source data field. The data to be pasted
must be within a displayed field. Data cannot be marked for pasting if it is in a
nondisplayable field. Data can be pasted from protected as well as unprotected fields.
The mark field must be selected before selecting the paste field.