Visara UCT-L - Manual (Page 29)

707108-001 4-5
Chapter 4. 1480 CUT Emulator
Selecting data fields
The application program may be designed to present to you certain fields that can be
selected for further processing by the application program. These fields are marked
with a “?”.
To select a field, perform one of the following actions:
• Press the CrSel key
• Move the cursor to cover any character in the field or to cover the “?” and click the
right mouse button.
“ > ” replaces the “?” associated with the field you select. If you accidentally select the
wrong field, press the CrSel key or right mouse button to deselect it.
To send the field(s) to the application program for processing, do one of the following,
depending on how the application program was designed:
• Press the Enter key.
• Press the CrSel key after positioning the cursor on an attention field. (Attention
fields are marked with &’s and spaces.)
• Position the mouse cursor to point to the desired attention field and click the right
mouse button.
Sending data
To send the displayed data to the host application before continuing to enter data:
1. Check to be sure that all fields required by the application have been filled.
Note: When a data character is entered in the next-to-last character position on the
screen, the audible alarm sounds to remind you that the cursor is near the end
of the screen. If data entry continues, the cursor “wraps”’ and reappears in the
first available character position of the screen. Subsequently entered characters
replace displayed characters, resulting in loss of previous entries.
2. Press the Enter key to send the displayed data to the host application.
3. Press the Clear key. This has the following effect:
• Erases all displayed data on the screen
• Returns the cursor to the first available character position
• Signals the host application that a “clear” operation has occurred.