Visara UCT-L - Manual (Page 43)

707108-001 4-19
Chapter 4. 1480 CUT Emulator
Dual Screen feature
The dual screen feature is provided by a special software program on the main logic
board. With the UCT-L Display Station in 1480 Emulation mode, you can display and
operate two sessions on one monitor in either a side-by-side format or a zoomed session
(that is, one of the two sessions occupies the entire display surface and you toggle
between the two sessions). Fields can also be copied from one session to the other. Dual
screen sessions are supported on a display configured as a Mod 2, 3, or 4.
Configuration requirements
To support Dual Screen mode, the controller must be configured for two or more logical
sessions on the display terminal’s port. In addition, PC File Transfer mode must be set
for those ports that use the Mark/Paste function of the UCT-L.
The UCT-L must be configured as follows to be able to exercise the enhanced dual
screen features:
• The UCT-L 1480 Emulator must be in either Mod 2, 3, or 4 mode with Partitioning
deselected. (See Defining and Selecting Features earlier in this chapter.)
• Host Addressable Printing must be disabled.
• The UCT-L must be configured for video mode of 1024 x 768.
Note: Only 122-key keyboards are supported.
The light pen is NOT supported in Dual Screen mode.
Configuring Dual Screen mode
From the 1480 CUT Emulator application:
1. Click Setup to open the 1480 Setup menu.
2. Click Screen.
3. Click the Dual Screen button (a green button indicates that Dual Screen mode is
enabled).
4. If the Controller Session Step Key is Alt - ChgSc (most 3174s), click the Controller
Step Key button to enable it. If the controller is configured for the Session Step Key
to be Alt - Insert (most 1174s will be configured this way) DO NOT click on the
Controller Step Key button.
5. Click OK to save changes.
Note: If later operation of Jump and Swap keys seem to not work correctly every
time, there may be a need to increase the delay between changing sessions.
Click the Increase Session Delay button to enable it.