Setting up the uct-l -4 connecting the uct-l -4, Connecting to the sna network -4, Setting up the uct-l – Visara UCT-L User Manual
Page 12: Connecting the uct-l, Uct-l user’s manual
1-4
707108-001
UCT-L User’s Manual
Setting up the UCT-L
To set up the UCT-L, refer to the diagram on the back of the logic unit and follow the
steps below:
CAUTION: The UCT-L has been designed to support the weight of 17-inch or smaller display units.
Display units larger than 17 inches MUST be placed beside the logic unit, rather than on top.
1. Place the display unit beside (preferred) or on top of the logic unit and position
both within connecting distance of an appropriate AC power outlet.
2. Make sure that the power is off, both on the logic unit and the display unit.
3. Place the keyboard in front of the logic unit. Pull out the feet underneath the keyboard
to adjust it to a higher setting, if desired. Insert the keyboard plug into the keyboard
connector on the back of the logic unit.
4. Refer to the owner’s manual that comes with your display unit for instructions on
how to attach the display unit’s data cable to the logic unit.
5. Plug the display unit’s AC power cable into an appropriate AC power outlet.
6. For the local screen print function, a printer connector is located on the back of the
logic unit. Attach the printer cable (provided with the printer) to the printer connector
on the back of the logic unit.
7. Insert the mouse’s cable connector into the mouse receptacle on the rear of the
logic unit. Check to ensure that the connector is firmly seated.
8. Plug one end of the power cable into the AC connector on the back of the logic unit.
Plug the other end of the AC power cable into the wall receptacle.
Connecting the UCT-L
Connecting to the SNA network
To connect the UCT-L to a coax wiring system, prepare either coax cables or twisted-
pair cables according to the following table:
x
a
o
C
r
i
a
P
d
e
t
s
i
w
T
h
t
g
n
e
l
m
u
m
i
x
a
M
)
t
e
e
f
0
2
9
4
(
s
r
e
t
e
m
0
0
5
1
)
t
e
e
f
0
0
9
(
s
r
e
t
e
m
7
7
2
Coax cable and twisted-pair cables can be combined. The following formula shows
lengths:
(coax length) + (5 x twisted-pair length) < 1370 meters (4500 feet)
1. Locate the coax or twisted-pair SNA network cable.
2. Align the end of the SNA network cable with the Coax connector on the back of the
logic unit.
3. Connect the cable and secure it in place by turning the retaining ring clockwise
until it is tight.