Visara UCT-L - Manual (Page 96)

6-34 707108-001
UCT-L User’s Manual
• Feature On/Off – Used to control serial port (com 3) usage with an alternate data
input device. (Serial bar code scanner, MICR scanner, Mag Stripe reader) (Serial
port not available on 300.)
• Session Name – Enter the name to be displayed in the window title.
• Line Turnaround Character – Allows selection of either ETX(0x03), EOT(0x04),
CR(0x0D), or DC3(0x13) as line turn around characters.
• Comm Mode – Will allow selection of Character Mode, Echo Mode or Local.
• Disconnect – Selects either 60mSec or 2 sec.
• Send – Effects function of Send Key...either Current Line or Current Page.
• Send Null Suppress – Selection On or Off...Controls suppression of transmission
of trailing null characters online.
• Bell (0x07) – Select Internal/External/Alt 1/Alt 2 for alarm.
• Serial (Serial port not available on 300.)
– Host – Enter a new host name or select from the drop-down list.
– Configure – Select to display the Serial Communications Configuration Panel.
Enter the Baud rate, parity, data bits and stop bits for the serial connection.
Click OK to save changes and close Communications Setup, or Cancel to close and
discard any changes.
Connecting to a 1451 session
1451 will connect to the remote host. The host then will normally respond with a welcome
and will lead you through its log in process. Log in, employing one of the following
combinations:
• With the userid and password supplied by the administrator of the host
• With just a userid (some hosts do not require passwords)
• Neither, if the remote host has been set up for it.
To connect to a 1451 remote host from the main 1451 screen:
1. Click Session to open the 1451 Session menu.
2. Click Connect.
Once connected, use the menus, commands and features of the remote host to access
and run 1451 applications.
Logging out of a remote host
1. When you have finished using the remote host, use the host’s normal log out command.
2. To disconnect from the host, select Disconnect from the Session menu.