Visara UCT-L - Manual (Page 35)

707108-001 4-11
Chapter 4. 1480 CUT Emulator
1480 Miscellaneous
Normally the 1480 emulator is running with the coax communications active over the
coaxial cable to the mainframe host controller. For instances where the user may want
to change a configuration item such as keyboard type (104 to 122) or mod size (Mod 2
to Mod 4), this screen provides the ability to make modifications to the emulator without
powering off the UCT-L and then powering it back on.
The user may make all the desired menu changes first. Some of the menu items such as
the two mentioned previously only take effect during the initial exchange of data with
the controller.
Restarting the 1480 Emulator
1. Click Setup in the upper left-hand corner of the screen to open the 1480 Setup
menu.
2. Click Miscellaneous. The 1480 Miscellaneous screen is shown below.
3. Click Coax Stop.
4. Click the OK button. This stops the 1480 from responding to the controller.
CAUTION: All data on the 1480 screen will be lost, along with the bridge data
transfers being stopped!
The 1480 screen data is erased and replaced by a large X. The operator symbol is placed
in the status row along with another X. This shows that the communications have been
halted.
5. Click Coax Start.
6. Click the OK button to restart the coax communications and initiate the exchange of
configuration items with the controller.
7. Click the Cancel button to exit this panel.