1 command line interface introduction, Command line interface introduction – Westermo PMI-110-F2G User Manual
Page 30
4.1
Command Line Interface Introduction
The Command Line Interface (CLI) is the user interface to the switch’s embedded
software system. You can view the system information, show the status, configure
the switch and receive a response back from the system by keying in a command.
There are some different command modes. Each command mode has its own
access ability, available command lines and uses different command lines to enter
and exit. These modes are User EXEC, Privileged EXEC, Global Configuration,
(Port/VLAN) Interface Configuration modes.
User EXEC mode: As long as you login the switch by CLI. You are in the User EXEC
mode. You can ping, telnet remote device, and show some basic information.
Type enable to enter next mode, exit to logout. ? to see the command list
Switch>
enable Turn on privileged mode command
exit Exit current mode and down to previous mode
list Print command list
ping Send echo messages
quit Exit current mode and down to previous mode
show Show running system information
telnet Open a telnet connection
traceroute Trace route to destination
Privileged EXEC mode: Press enable in the User EXEC mode, then you can enter
the Privileged EXEC mode. In this mode, the system allows you to view current
configuration, reset default, reload switch, show system information, save
configuration…and enter the global configuration mode.
26