Westermo PMI-110-F2G - Manual (Page 9)

and secure network connection. To optimize industrial network environment the switch
supports advanced network features, such as Tag VLAN, IGMP Snooping, Quality of Service
(QoS), Link Aggregation Control Protocol (LACP), Rate Control, etc. The PoE switch can be
smartly configured through WeDashboard, Web Browser, SNMP, Telnet and RS‐232 local console
with its command like interface. The failure notifications are sent through e‐mail, SNMP trap,
Local/Remote system log, Multiple event alarm relay.
To avoid hacker’s attacks and ensure the secure data transmission, PMI‐110‐F2G series features
DHCP client, DHCP server with IP and MAC binding, 802.1X Access Control, SSH for Telnet
security, IP Access table, port security and many other security features.
1.2 Major Features
Westermo PMI‐110‐F2G Switch have following features:
„ 8 10/100 Base TX PoE ports and 2 Gigabit RJ/ SFP combo ports
„ IEEE 802.3af 15.4W / IEEE 802.3at 30W High Power PoE
„ 120W total power budget for High‐power PoE camera
„ SFP ports support 100/1000 Mbps with Digital Diagnostic Monitoring (DDM) to
monitor long distance fiber quality
„ All ports support 5ms recovery time, and MSR for up to 4 x 100M Rings plus 1 Gigabit
Ring
„
Advanced management by LACP/VLAN/Q‐in‐Q/Private VLAN/ GVRP/ QoS/ IGMP
Snooping/Rate Control/ Online Multi‐Port Mirroring/ Advanced DHCP server, Client
„ Advanced Security system by Port Security, Access IP list, SSH and HTTPS Login
„ Event Notification through E‐mail, SNMP trap and SysLog
„ Supports console CLI , Web, LLDP, SNMP, RMON, and WeDashboard for remote
management
„ Multiple event relay output for enhanced device alarm control
„ Hi‐Pot Isolation Protection for ports and power
„ Industrial Heat dispersing design, ‐40~70˚C wide operating temperature
5