Westermo PMI-110-F2G - Manual (Page 32)

Global Configuration Mode: Press configure terminal in privileged EXEC mode.
You can then enter global configuration mode. In global configuration mode, you
can configure all the features that the system provides you.
Type interface IFNAME/VLAN to enter interface configuration mode, exit to
leave. ? to see the command list.
Available command lists of global configuration mode.
Switch(config)#
administrator Administrator account setting
arp Set a static ARP entry
clock Configure time-of-day clock
default Set a command to its defaults
dot1x IEEE 802.1x standard access security control
end End current mode and change to enable mode
ethertype Ethertype
exit Exit current mode and down to previous mode
gmrp GMRP protocol
gvrp GARP VLAN Registration Protocol
hostname Set system's network name
interface Select an interface to configure
ip IP information
lacp Link Aggregation Control Protocol
list Print command list
lldp Link Layer Discovery Protocol
log Logging control
mac-address-table mac address table
mirror Port mirroring
modbus Modbus TCP Slave
multiple-super-ring Configure Multiple Super Ring
nameserver DNS Server
no Negate a command or set its defaults
ntp Configure NTP
poe Configure power over ethernet
ptpd IEEE1588 Precision Time Protocol
qos Quality of Service (QoS)
relay relay output type information
router Enable a routing process
sfp Small form-factor pluggable
smtp-server SMTP server configuration
snmp-server the SNMP server
spanning-tree the spanning tree algorithm
trunk Trunk group configuration
vlan Virtual LAN
warning-event Warning event selection
write-config Specify config files to write to
Switch(config)#
(Port) Interface Configuration: Press interface IFNAME in global configuration
28