Westermo PMI-110-F2G - Manual (Page 44)

Once you finish your configuration, click on Apply to activate your configuration.
4.2.5 DHCP Server
You can select to Enable or Disable DHCP Server function. PMI switch will assign
a new IP address to link partners.
DHCP Server configuration
After selecting to enable DHCP Server
function, type in the Network IP address
for the DHCP server IP pool, Subnet Mask,
Default Gateway address and Lease Time
for client.
Once you have finished the configuration,
click Apply to activate the new
configuration.
Excluded Address:
You can type a specific address into the IP
Address field for the DHCP server reserved
IP address.
The IP address that is listed in the Excluded
Address List Table will not be assigned to
the network device. Add or remove an IP
address from the Excluded Address List by
clicking Add or Remove.
Manual Binding: PMI Switch provides a
MAC address and IP address binding
and removing function. You can type in
the specified IP and MAC address, and
then click Add to add a new MAC&IP
address binding rule for a specified link
partner, like PLC or any device without
DHCP client function. To remove from
the binding list, just select the rule to
remove and click Remove.
DHCP Leased Entries: PMI Switch
provides an assigned IP address list for
user check. It will show the MAC and IP
40