Westermo PMI-110-F2G - Manual (Page 34)

Summary of the 5 command modes.
Command
Mode
Main Function Enter and Exit Method Prompt
User EXEC This is the first level of access.
User can ping, telnet remote
device, and show some basic
information
Enter: Login successfully
Exit: exit to logout.
Next mode: Type enable to enter
privileged EXEC mode.
Switch>
Privileged EXEC In this mode, the system allows you
to view current configuration, reset
default, reload switch, show system
information, save
configuration…and enter global
configuration mode.
Enter: Type enable in User EXEC
mode.
Exec: Type disable to exit to user
EXEC mode.
Type exit to logout
Next Mode: Type configure
terminal to enter global
configuration command.
Switch#
Global
configuration
In global configuration mode, you
can configure all the features that
the system provides you
Enter: Type configure terminal in
privileged EXEC mode
Exit: Type exit or end or press
Ctrl‐Z to exit.
Next mode: Type interface
IFNAME/ VLAN VID to enter
interface configuration mode
Switch(config)#
Port
Interface
configuration
In this mode, you can configure
port related settings.
Enter: Type interface IFNAME in
global configuration mode.
Exit: Type exit or Ctrl+Z to global
configuration mode. Type end to
privileged EXEC mode.
Switch(config‐if)#
VLAN Interface In this mode, you can configure Enter: Type interface VLAN VID Switch(config‐vlan)#
Switch(config)# interface vlan 1
Switch(config-if)#
description Interface specific description
end End current mode and change to enable mode
exit Exit current mode and down to previous mode
ip Interface Internet Protocol config commands
list Print command list
no Negate a command or set its defaults
quit Exit current mode and down to previous mode
shutdown Shutdown the selected interface
30