H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 14)

6
Main control boards
The WX6103 supports flexible main control board configuration. Based on your specific requirement, the
WX6103 is operable with only one main control board or with two main control boards working in
redundant or independent mode.
Main control board specifications
Table 4 Technical specifications for the EWPXM1WCMB0 and EWPX1WCMD0
Item EWPXM1WCMB0 EWPX1WCMD0
CPU MIPS64, 600 MHz XLR732 950MHz
Boot ROM 512 KB 4 MB (dual-BootWare)
DDR memory 1 GB 2 GB
Console port
One console port, with the
transmission speed of 9600 bps to
115200 bps, 9600 bps by default
Supports local or remote
configuration and management
through dial-up connection
One console port, with the
transmission speed of 9600 bps
to 115200 bps, 9600 bps by
default
Supports local or remote
configuration and management
through dial-up connection
Management Ethernet interface
One 10/100/1000Base-T
management Ethernet interface One 10/100/1000Base-T
management Ethernet interface
USB interfaces
Two USB interfaces, working in
HOST mode Two USB interfaces, working in
HOST mode
CF card Built-in 256 MB CF card Built-in 1 GB CF card
Reset button One reset button One reset button
Dimensions (H × W × D)
40.1 × 366.7 × 340 mm (1.58 ×
14.44 × 13.39 in) 40.1 × 366.7 × 340 mm (1.58 ×
14.44 × 13.39 in)
Power consumption range 51 W to 75 W 72 W to 100 W
Main control board front panel
Figure 7 Front panel of the EWPX1WCMB0
1: Captive screw 2: USB interface
3: Management Ethernet interface 4: Management Ethernet interface LEDs
5: Console port 6: Slot status LEDs
7: Fan status LEDs 8: ACTIVE LED
9: Reset button