H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 27)

19
Installing the access controller
CAUTION:
To avoid bodily injury, do not touch any wire, terminal, or part marked with a high-voltage hazard sign.
Inspecting the access controller
Follow these steps before installing a WX6103 access controller:
• Make sure that you have read the chapter “Preparing for installation” carefully and the installation
site meets all the requirements.
• Using the packing list supplied with your access controller, inspect the access controller to be sure
that you have all the items listed in the packing list, and verify that the access controller was not
damaged during shipment. If anything is damaged or missing, contact the H3C customer
representative immediately.
• For regulatory compliance and safety information, see the H3C WX6103 Access Controller
Compliance and Safety Manual.
Installation flowchart
Figure 13 Installation flowchart
Start
Connect the
grounding cable
Install the generic
modules
Connect the
power cables
Connect the
interface cables
Cabling and
cable binding
Check the installation
End
On a workbench On a cabinet