H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 81)

73
|<7> BootWare Operation Menu |
|<8> Clear Super Password |
|<9> Storage Device Operation |
|<0> Reboot |
==========================================================================
Enter your choice(0-9): 0
Step7 Select 0 in the BootWare main menu to reboot the access controller.
Upgrading the BootWare through a serial connection
Follow these steps to upgrade the BootWare through a serial connection:
Step1 Enter the BootWare main menu (see “ BootWare menus .”) and select 7 to enter the BootWare operation
submenu. For more information about this menu, see “ BootWare operation submenu .”
Step2 Select 3 in the BootWare operation submenu to enter the BootWare operation serial interface submenu:
======================<BOOTWARE OPERATION SERIAL SUB-MENU>======================
|<1> Update Full BootWare |
|<2> Update Extend BootWare |
|<3> Update Basic BootWare |
|<4> Modify Serial Interface Parameter |
|<0> Exit To Main Menu |
================================================================================
Enter your choice(0-4):
Step3 Select 4 in the BootWare operation serial interface submenu. The system prompts you to modify the baud
rate.
=================================<BAUDRATE SET>=================================
|Note:'*'indicates the current baudrate |
| Change The HyperTerminal's Baudrate Accordingly |
| Press 'Enter' to exit with things untouched. |
|-----------------------------<Baudrate Avaliable>-----------------------------|
|<1> 9600(Default)* |
|<2> 19200 |
|<3> 38400 |
|<4> 57600 |
|<5> 115200 |
|<0> Exit |
================================================================================
Enter your choice(0-5):
Step4 Change the communication baud rate by referring to “ Modifying serial communication parameters .”
After the modification, the system displays the following information:
Baudrate has been changed to 115200 bps.
Please change the terminal's baudrate to 115200 bps, press ENTER when ready.
The current baudrate is 115200 bps
=================================<BAUDRATE SET>=============================
|Note:'*'indicates the current baudrate |
| Change The HyperTerminal's Baudrate Accordingly |
|---------------------------<Baudrate Avaliable>---------------------------|
|<1> 9600(Default) |