H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 26)

18
Installation tools and meters
Table 17 List of installation tools and meters
Type Tools
Measure and
marking tools Long tapes, rulers (1 meter long), gradienters, marking pens,
powder markers, pencils
Drills and
accessories
One percussion drill, drill bits as required, one vacuum cleaner
Fastening tools
• Flat-blade screwdriver, P4-75 mm
• Phillips screwdrivers, P1-100 mm, P2-150 mm, and P3-250 mm
• Socket wrenches, M5
• Socket wrenches, M6
• Box end wrenches, M6
• Double box-end wrenches (10×12) or double open-end wrenches
(10×12)
Small tools
Sharp-nose pliers, diagonal pliers, vices, hand-held electric drills,
file, handsaws, crowbars, rubber hammers
General tools
Auxiliary tools
Brushes, tweezers, paper cutters, hand bellows, electric irons, solder
wires, forks, ladders
Special tools
ESD-preventive wrist straps, cable strippers, crimping pliers, RJ-45 connector crimping
pliers, wire punchdown tools
Fiber cleaning
tools
Airlaid paper, fiberscope
Meters
Multimeters, 500V Meg-ohmmeter (for measuring insulation resistance), BER testers,
optical power meters, earth resistance testers
NOTE:
The above-mentioned tools and meters are not shipped with the WX6103 access controller.