H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 16)

8
Item Specification
MDI/MDI-X MDI/MDI-X autosensing
Interface speed
10 Mbps, half duplex/full duplex
100 Mbps, half duplex/full duplex
1000 Mbps, full duplex
Medium and maximum transmission distance
Direct-through or crossover Category-5 twisted pair cable,
with a maximum transmission distance of 100 m (328.1 ft)
Function
Host software and Boot ROM upgrade and network
management
Table 7 describes the status LEDs of the Ethernet interface.
Table 7 Description of the management Ethernet interface status LEDs
LEDs Meaning
LINK (green)
• Off—the network cable is not connected.
• Steady on—the network cable is connected.
ACT (orange)
• Off—no data is being transmitted/received.
• Blinking—data is being transmitted/received.
Console port
The WX6103 provides an RS-232 asynchronous serial console port (CON) using an RJ-45 connector. The
console port can be connected to a computer for system debugging, configuration, maintenance,
management, and host software loading.
Table 8 Technical specifications for the console port
Item Specification
Connector type RJ-45
Number of interfaces 1
Interface standard Asynchronous EIA/TIA-232
Baud rate
9600 bps to 115200 bps
9600 bps by default
Transmission distance ≤15 m (49.21 ft)
Functions
• To connect with a character terminal
• To connect with the serial interface of a local PC
running a terminal emulation program for access
controller configuration
• Command line interface
Reset button
The reset button (RESET) is used to restart the current active main control board.
• If the access controller has only one main control board, pressing the reset button reboots the
access controller.