H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 19)

11
Item Description
SFP transceiver module types
See the chapter “Specifications for transceivers and
interface cables.”
XFP transceiver module types
See the chapter “Specifications for transceivers and
interface cables.”
Switch interface board front panel
Figure 11 Front panel of the EWPX1G24XA0
1: Captive screw 2: Electrical Gigabit Ethernet ports (ports 1 through 20)
3: Electrical Gigabit Ethernet ports (combo ports,
ports 21 through 24) 4: Optical combo ports
5: MOD LED 6: 10GE interface module
NOTE:
Ports 21 through 24 among the GE ports are combo ports. These combo ports share the same data
channels with the SFP Combo ports shown in callout 4 in
Figure 11 , so these two sets of combo ports
cannot be used at the same time.
Provided interfaces
Electrical Gigabit Ethernet ports
The switch interface board provides twenty-four electrical GE ports, among which four are Combo ports
(ports 21, 22, 23, and 24).
Table 11 Technical specifications for the electrical GE ports
Item Specification
Connector type RJ-45
Number of interfaces 24
Interface speed
• 10 Mbps, half duplex/full duplex
• 100 Mbps, half duplex/full duplex
• 1000 Mbps, half duplex/full duplex
• MDI-X
Medium and maximum transmission distance
Category-5 twisted pair cable, with a maximum
transmission distance of 100 m (328.1 ft)
Functions Service data transmission