H3C Technologies H3C WX6000 Series Access Controllers User Manual
Page 56
48
# Configure the username as admin, password as admin, and user privilege level as 3 (manage level).
[H3C] local-user admin
[H3C-luser-admin] service-type telnet
[H3C-luser-admin] authorization-attribute level 3
[H3C-luser-admin] password simple admin
[H3C-luser-admin] quit
4.
Use the oap command to log in to the switch interface board (with the sysname name Sysname in
this example).
<H3C>oap connect slot 0
Press CTRL+K to quit.
Connected to OAP!
<Sysname>
5.
Configure the IP address of VLAN-interface 1 of the switch interface board of the access controller
as 192.168.0.101/24.
<Sysname> system-view
[Sysname] interface Vlan-interface 1
[Sysname-Vlan-interface1] ip address 192.168.0.101 24
[Sysname-Vlan-interface1] quit
6.
Add the interface on the switch interface board that connects the switch interface board to the PC
to VLAN 1. By default, all GE interfaces on the switch interface board belong to VLAN 1.
[Sysname]interface GigabitEthernet0/0/1
[Sysname-GigabitEthernet0/0/1]undo port access vlan
NOTE:
The access controller has the default web login information when shipped. You can use the default
information to log in to the web interface. The default information is: username admin, password admin,
IP address of VLAN-interface 1 of the main control board 192.168.0.100/24, and IP address of
VLAN-interface 1 of the switch interface board 192.168.0.101/24.
7.
Configure an IP address for the PC, for example, 192.168.0.10/24, and make sure that the PC
and the access controller can reach each other.
8.
On the PC, open the browser, type the IP address 192.168.0.1 in the address bar, press Enter
and you can enter the login page of the web interface, as shown in
. Input the username
admin, the password admin, and the verify code, select the language (English or Chinese), and
click Login.
Figure 42 Web login page