H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 15)

7
Figure 8 Front panel of the EWPXM1WCMD0
1: Captive screw 2: USB interface
3: Management Ethernet interface 4: Management Ethernet interface LEDs
5: Console port 6: Slot status LEDs
7: Fan status LEDs 8: ACTIVE LED
9: Reset button
Provided interfaces
USB interfaces
The WX6103 provides two Type-A USB1.1 interface. As the host end, the USB interfaces connect external
USB devices, USB hard drives for example, to extend the storage space of the wireless access controller
to facilitate file and log information storage.
Table 5 Technical specifications for the USB interfaces
Item Specification
Connector type USB-A
Number of interfaces 2
Interface speed 1.5 Mbps
Maximum transmission distance 5 m (16.40 ft)
Note:
•
H3C recommends you to use the USB hard drive provided by H3C. H3C does not guarantee the
compatibility and reliability of the USB interfaces working with third-party USB hard disk drives.
• The USB hard drive has a status LED. Do not remove the USB hard drive when the LED is blinking
because this may damage the file system on the USB hard drive.
Management Ethernet interface
The management Ethernet interface is a 10/100/1000Base-TX RJ-45 port. It can be connected to a
background computer for system program loading and debugging, or connected to a remote NMS for
remote software upgrade and device management without taking a service interface. The management
Ethernet interface is designed for system management, and it does not have any service processing
capability.
Table 6 Technical specifications for the management Ethernet interface
Item Specification
Connector type RJ-45
Number of interfaces 1