Grass Valley iControl V.4.43 - Manual (Page 341)

iControl
User Guide
331
Defining Permissions in a Role
To define permissions in a role
1. In the Privilege Management window, click the Role Definition tab.
The Role Definition panel appears.
2. In each role column, click to put a check mark in the row corresponding to a permission you
wish to assign.
3. Click Apply to save your changes and continue, or click OK to save the changes and close
the Privilege Management window.
Assigning Resources
Cards and services make themselves available as resources under access control when they
first start up. For example, as a card inside a Densité frame boots, it starts a service on the GSM
that checks to see if access control is enabled. If it is, then the card adds itself to the LDAP
directory, and appears as a resource within the Privilege Management window.
Assigning Permissions to Cards and Services Based on Role Types
To assign permissions to cards and services based on role types
1. In the Privilege Management window, click the Resource Assignment tab.
The Resource Assignment panel appears.
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• You have opened iControl (see page 696 ).
• You have opened iC Navigator (see page 719 ).
• You have opened the Privilege Management window (see page 708 ).
Note: The superuser role always has all permissions.
Note: Click in the row corresponding to a folder to assign all of the folder’s actions.
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• You have opened iControl (see page 696 ).
• You have opened iC Navigator (see page 719 ).
• You have opened the Privilege Management window (see page 708 ).