Grass Valley iControl V.4.43 - Manual (Page 429)

iControl
User Guide
419
Inverting Alarms Manually
To manually invert alarms in iC Web or iC Navigator
1. Open the GSM Alarm Browser (see page 732 ).
2. If you would like to perform the inversion action in iC Navigator’s Incident Log Viewer,
open Incident Log Viewer (see page 724 ).
3. Make sure the current setting for manual grace period duration is the desired duration
period by performing the following steps.
a) In the GSM Alarm Browser, click the Admin tab, and then click the Configuration tab.
Figure 7-99
b) In the Properties area, edit the grace period in the Manual grace period duration
field, as required.
c) Click Save.
IMPORTANT: If your network is configured to report alarms to multiple GSMs, it is
recommended that you configure the same Grace period duration for manual
inversions among all GSMs. Similarly, it is recommended that you configure the
same Grace period duration for scheduled inversions among all GSMs.
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• If you are working in iC Web, make sure you have opened the required iControl Web
page (see "Working with iC Web" , on page 741).
• If you are working in iC Navigator, make sure you fulfill the following conditions before
beginning this procedure:
• You have opened iControl (see page 696 ).
• You have opened iControl Navigator (see page 719 ).