Grass Valley iControl V.4.43 - Manual (Page 422)

Alarms in iControl
Acknowledging a Channel Alarm
412
Acknowledging a Channel Alarm
To acknowledge a channel alarm
• Perform only one of the following steps:
• Right-click on a thumbnail, and then click Acknowledge.
• Right-click an individual alarm on the channel’s Web page, and then click
Acknowledge.
Once the channel alarm is acknowledged, the button changes from flashing red to solid red.
Acknowledging More Than One Channel Alarm
To acknowledge more than one channel alarm
• Right-click on a channel group number, and then click Acknowledge.
All the channels within the selected group are acknowledged and the buttons change from
flashing red to solid red.
Resetting Latches on Web Pages
To reset a latch
• Perform only one of the following steps:
• Right-click on a thumbnail, and then click Reset client latch or Reset server latch, as
required.
• Right-click an individual alarm on the channel’s Web page, and then click Reset client
latch or Reset server latch, as required.
Once the channel alarm is acknowledged the button changes from flashing red to solid red.
Viewing Acknowledgments and Latches in Event Log Viewer
A new log entry is created for each change in a particular status, including changes to a server
latch or alarm acknowledgment.
REQUIREMENT
Before beginning this procedure, make sure you have opened the appropriate iControl Web
page (see
"Working with iC Web" , on page 741).
REQUIREMENT
Before beginning this procedure, make sure you have opened the appropriate iControl Web
page (see
"Working with iC Web" , on page 741).
REQUIREMENT
Before beginning this procedure, make sure you have opened the appropriate iControl Web
page (see
"Working with iC Web" , on page 741).