Grass Valley iControl V.4.43 - Manual (Page 483)

iControl
User Guide
473
Creating an Alarm Map
There are several ways in which you can create an alarm map. The differences lie in the way in
which you navigate to the Create Alarm Map window.
To create an alarm map
1. Open the Create Alarm Map window by doing only ONE of the following:
• In SNMP Driver Creator, on the Alarms tab, click New alarm map.
Figure 8-56
OR,
• In either the Add Alarm window or the Edit Alarm window, click New alarm map.
See also
For more information about editing an existing alarm any time after it has been created,
see
page 487 .
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• You have opened SNMP Driver Creator (see page 737 ).
• you have loaded a MIB module into SNMP Driver Creator (see page 462 ).